BATL+

The new BATL+® Stationary Infantry Target is a stand alone training device that can be integrated into a system of systems increasing the training value for today’s Warfigher. The ability to be controlled individually, in groups, or in a scenario with our intuitive control system, allows for on site scenario development in response to all training situations. Able to operate in all environments, completely impervious to all climate and weather. Environmentally friendly containing no hazardous contaminates or fluids.

  • External control panel with on/off, power button and programmable LED
  • User defined hits to kill, and sensitivity levels
  • IR/MF simulator for low light engagements
  • Auxiliary ports configurable for momentary or constant 12 vdc
  • 35 amp / 12 vdc battery or AC power converter
  • Three communication modes: hardwire, 802.11ac, & RF
  • LTRaC & FASIT compliant
  • TRACR & RISCON-T compatible

ATA Defense Conversion

The Patriot Products Stationary Infantry Target (SIT) conversion is an upgrade package designed to extend the service life of functional and non-functional ATA Defense Industries Portable Infantry Target Systems (PITS). Designed for use with the Patriot Range Controller (PRC) this conversion package upgrades the ATA Defense lifter electronics and communications, while adding the Patriot Products Target Information and Management System (TIMS) which includes GPS location reporting, maintenance status messaging, and inventory reporting.

  • Conversion includes: Main Control Board, GPS, Inventory Chip, SIT Daughter Board, Reversing Relay, wiring harness and communication protocol.
  • Three communication modes: Hardwire, Wi-Fi,
    and RF.
  • Conversion comes with upgraded firmware
    pre-installed.
  • Must be used with the Patriot Range Controller (PRC)
  • TIMS system allows accurate reading of battery voltage (DC), maintenance issue reporting, and inventory management (existing serial numbers can be programmed into the TIMS system for continued inventory continuity.
  • Mechanical repair parts also available for non-functional ATA units.